66
English
Network settings
Set when networking with a computer.
[Network settings] submenu will be displayed.
Network settings
Network control
EQ1-000
Off
Off
Off
Display name
Network status
LAN setup
AMX D. D.
Crestron Connected
Reset
OffAuto display name
Permit
USB memory network settings
Protocol 2LAN control protocol
■ [Network control]
Set when controlling with the unit’s LAN terminal.
[On]:
Controls via LAN using the LAN terminal. The
power indicator lights orange when the power is
turned off with the remote control (standby).
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
Note
●
When using the LAN control function which is
described in “Using Network Function” (see page
76‒91), set this function to [On].
●
Even if the setting is set to [Off], the Web browser
control screens that do not control this unit (display
information [Status], detailed settings [Detailed set
up] and password change [Change password])
operate.
■ [Auto display name]
Sets whether to change the display name automatically.
[On]:
Changes the display name automatically in
accordance with the set point of the display ID.
[Off]:
The display name is not changed automatically.
■ [Display name]
The name of the Display that is shown on the network
can be changed.
Note
●
The name can be changed only when [Auto display
name] is set to [Off].
●
Display ID is not reset to default with [Network
settings] - [Reset].
■ [LAN setup]
Detailed network settings for the LAN can be configured.
Select [LAN setup] with
and press <ENTER>.
192.168. 0. 8
255.255.255. 0
192.168. 0. 1
1024
12:34:56:78:9A:BC
LAN setup
Save
DHCP Off
IP address
Subnet mask
Gateway
Command port
MAC address
[DHCP], [IP address], [Subnet mask], [Gateway]
Press to set [On] / [Off] of [DHCP].
When [Off] is selected, IP address and other settings
can be set manually.
[DHCP]:
(DHCP client function)
[On]:
Obtains an IP address automatically when a DHCP
server exists in the network the Display is going to
be connected.
[Off]:
When a DHCP server does not exist in the network
the Display is going to be connected, set [IP
address], [Subnet mask] and [Gateway] manually.
[IP address]:
(IP address display and setting)
Enter an IP address when DHCP server is not
used.
[Subnet mask]:
(Subnet mask display and setting)
Enter a Subnet mask when DHCP server is not
used.
[Gateway]:
(Gateway address display and setting)
Enter a gateway address when DHCP server is
not used.
Note
●
When [DHCP] is set to [On], the IP address, etc.
will be displayed in grey.
Entering numbers
I
192.168.000.008
IP address
1. Select the address and press <ENTER>.
2. Select digits with
.
3. Change numbers with
.
4. Press <ENTER>.
You can cancel the change by pressing
<RETURN>.
Select [Save] and press <ENTER>.
Save the current network Setup.
To Next Page
Loading...
