29
HEAT STATUS
This function allows you to check the thermal status of this
Display at any time.
EXIT MENU
:RETURN :EXIT MENU
HEAT STATUS
COOLING FAN
OFF
TEMPERATURE:
SENSOR 1
SENSOR 2
35.7 C / 96.2 F
30.2 C / 86.3 F
SCREEN SAVER
Choose to enable the panel saving functions to reduce the
risk of the “image persistence”.
EXIT MENU
:SEL +-:ADJ :RETURN :EXIT MENU
SCREEN SAVER
COOLING FAN
BRIGHTNESS
MOTION
AUTO
OFF
OFF
• {COOLING FAN} - Select {ON} to turn on the cooling fan
all the time. Select {AUTO} to turn on/off the cooling fan
according to this Display’s temperature.
NOTES:
• The default {AUTO} option will start running the cooling
fan if the temperature of 65 °C (152 °F) is reached,
and will keep running for 30 minutes after cooling
down to the temperature of 62 °C (144 °F).
• A temperature-warning message will be shown on the
screen once the temperature reaches 79 °C. All key
function except [Power] key will then be disabled.
• Once the temperature reaches 80 °C (176 °F), this
Display’s power will be shut down automatically.
• {BRIGHTNESS} - Select {ON} and the brightness of
the image will be reduced to an appropriate level, and
the Brightness setting in the Picture menu will become
unavailable.
• {MOTION} - Select the time interval ({10 ~ 900} Seconds
/ {OFF}) for this Display to slightly expand the image size
and shift the position of pixels in four directions (up, down,
left, or right).
SIDE BORDER COLOR
Adjust the brightness of the black areas displayed on both
sides of 4:3 images.
CONFIGURATION3 RESET
Reset all settings in the CONFIGURATION3 menu to factory
preset values.
ADVANCED OPTION menu
1
2
3
SET EXIT MENU
:SEL :NEXT
INPUT CHANGE
TERMINAL SETTING
COLOR SYSTEM
SCAN MODE
SERIAL CONTROL
LAN SETTING
ADVANCED OPTION RESET
FACTORY RESET
:RETURN :EXIT MENU
NORMAL
AUTO
INITIAL INPUT
OFF
OVERSCAN
RS - 232C
ADVANCED OPTION
INPUT CHANGE
Select the time for input switching as {NORMAL} or {QUICK}.
NOTE: The selection {QUICK} may cause a slight noise.
TERMINAL SETTING
Select the mode to display the HDMI or DVI signal according
to their signal format depending on their source device.
• {DVI MODE}: Used for DVI-D signal.
• Select {DVI-PC} when the source device is a PC.
• Select {DVI-HD} when the source device is a video
device.
• {HDMI SIGNAL}: Used for HDMI signal.
• Select {LIMITED} when displaying the signal that uses
16 to 235 levels of 256 levels for each R, G, and B.
• Select {FULL} when displaying the signal that uses all
256 levels (from level 0 to 255).
1
2
3
EXIT MENU
:SEL +-:ADJ
DVI-MODE
HDMI SIGNAL
:RETURN :EXIT MENU
DVI-PC
FULL
ADVANCED OPTION
TERMINAL SETTING
COLOR SYSTEM
Selects the Color System depends on your input video format.
The options are: {AUTO} / {NTSC} / {PAL} / {SECAM} /
{4.43NTSC} / {PAL-60}.
NOTE: This item is functional for VIDEO input only.
SCAN MODE
Change this Display’s area of the image.
• {OVERSCAN} - Display about 95% of the original size of
the image. The rest of the areas surrounding the image
will be cut off.
• {UNDERSCAN} - Display the image in its original size.
To Next Page
Loading...
