Panasonic Toughbook CF-C1ADAAZ6M - Page 186

186
Troubleshooting (Advanced)
• Slide the drive power/open switch and open the disc cover.
• Click on the notification area, and confirm [On] in [Manual switching] of [The optical disc drive’s power].
• Right-click on the notification area, and click [On] in [Manual Switching].
 In the Setup Utility, is [Optical Drive Power] set to [Off]? ( page 161)
If this is set to off, unless Windows is running, it is not possible to turn on the drive.
<CF-S10 Series>
Disc playback and writing is not possible
 Make sure the inserted disc is a compatible media type. For more about compatible media types, see “Disc Information”
( page 78).
 You may need to clean the disc. ( page 74)
 Check whether the disc is distorted, damaged, or dirty.
 When inserting a disc, follow the procedure below. Make sure the disc is inserted securely.
A Slide the drive power/open switch, and open the disc cover.
B Slide the disc into the drive under the keyboard with the label side up.
C Press firmly on the center of the disc until you hear it click into place.
<CF-S10 Series>
When a disc is inserted, it is not played automatically
 Remove the disc and reinsert it.
• If an AutoPlay CD does not start after the computer resumes from the sleep or hibernation, remove the disc from the
drive, then reinsert the disc again after a 15 second wait.
 Follow the procedure below.
A Click (Start) - [Control Panel] - [Hardware and Sound] - [Play CDs or other media automatically].
B Click right of the item you want to automatically play and choose the action to play.
C Click [Save].
If the problem persists, refer to the disc’s operating instructions or other sources to play the disc.
 In the CD/DVD drive properties, click [AutoPlay], and when [Take no action] is set under [Select an action to perform],
select the items to be played automatically.
Windows 7
Windows XP
Windows 7
Windows XP