http://servis-manual.com/
4 Self Check
TOP PREVIOUS NEXT
1.Self-Check is used to automatically check the bus lines and hexadecimal code of the TV set.
2.To get into the Self -Check mode press the Down (
) button on the customer controls at the front of the set, at the same time pressing the Recall
button on theremote control, and the screen will show :
3.Turn off the TV to reset JPEG Viewer circuit after SELF-CHECK.
If the CCU ports have been checked and found to be incorrect or not located then “--” will appear in
place of “O.K.”.
TOP PREVIOUS NEXT
Display Ref .No. Description P.C.B.
MEM IC1107 EEPROM DG-Board
GC3FM IC4017 Global Core MAIN DG-Board
GC3I IC4003 Global Core DG-Board
HAD IC4001 SCART RGB A/D Converter DG-Board
HAD2 IC4002
OSD RGB A/D Converter DG-Board
AVSW1 IC3001 AV Selector A-Board
Tun1 TU101 Tuner B-Board
MSP IC2501 Stereo Decoder A-Board
To Next Page
Loading...
