Panasonic TX-51P800X - Rear Cover (Bottom); Disassembly for CRT Removal

3.9. Rear Cover (Bottom)
1.Remove (16) screws.
2.Remove (1) screw.
3.10. Disassembly For CRT Removal
To facilitate CRT replacement, the complete CRT mounting
chassis does not need to be removed.
1.Remove the Screen Frame Ass´y, Decorative Panel and
the Bottom Rear Cover Ass´y. ( See Disassemble for
Service ).
2.Unplug the defective CRT Dag ( GND ), from the CRT
Board, LBGND for LB, LGGND for LG, LRGND for LR.
3.Remove lead wires ( DY, VM coil ) and anode lead wire
from holders as necessary.
4.Remove the CRT Board from the defective CRT neck.
5.Note position of yoke with centering tabs and remove from
defective CRT.
6.From the Top, remove (2) screws from the defective CRT.
10
TX-51P800X / TX-51P800HM / TX-51P800HQ / TX-43P800X / TX-43P800HM / TX-43P800HQ / TX-43P800HZ