- 41 -
Reference
F99
h The unit fails to operate properly. Press [Í/I]
on the main unit for 3 seconds to switch the
unit to standby, then switch back on.
NET
h While connecting to a network.
NO PLAY
h There is a viewing restriction on a BD-Video
or DVD-Video. (> 34)
h A DVD-Video disc with an incompatible region
code is inserted.
NO READ
h The media is dirty or badly scratched. The
unit cannot play.
REMOVE
h The USB device is drawing too much power.
Remove the USB device.
SET CODE ∏
(“ ” stands for a number.)
h The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold
[OK] and the
indicated number
button at the same time for more than
5 seconds.
U59
h Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
START
h A firmware update will start. Please do not
turn off the unit.
UPDATE /5
(“ ” stands for a number.)
h A firmware update is in progress.
Please do not turn off the unit.
FINISH
h The firmware update is complete.
Messages on the unit’s
display
DP-UB820-EB-TQBS0208-4_eng.book 41 ページ ２０１９年６月２７日 木曜日 午後１２時０分
To Next Page
Loading...
