Displaying PC Screen on TV
The screen of the PC connected to the unit can be displayed on the TV.
You can also listen to PC sound with the audio cable connected. To connect PC (p. 43)
Display the Input select menu
INPUT
(example)
Select "PC"
Displays
PC screen
INPUT
• To return to TV _ ÷ _/
® Corresponding signals
(p.48)
• PC menu setting (change as desired)
® Making settings ÷ "How to Use Menu Functions"@ to 0 (p. 27)
Menu
Item • Adj ustments/Configu rations (options)
Resetto defaults Resets PC adjustments. Confirmation screen is displayed. Select "Yes" and press OK to reset.
® H & V: The H and V sync signals are input from the HD/VD connector. (p. 49)
® On green: Uses a synchronized signal on the Video G signal, which is input from the
G connector. (p. 49)
Alleviates the problem if a picture appears to be vertically-striped, flickers partially or is blurred.
Sync
Dot clock
H-position
V-position
Clock phase
Input
resolution
H-frequency
V-frequency
Adjusts the horizontal position. _/_ __ J Oi.l@,O oO
Adjusts the vertical position. _ O _-,/
Alleviates the problem if the whole picture appears to flicker or is blurred.
First adjust the Dot Clock to get the best possible picture, then adjust the
Clock Phase so that a clear picture appears.
It may not be possible to display a clear picture due to poor input signals.
Switches to wide display.
® Input signal switched from 640x480 to 852x480
@ Input signal switched from 1024x768 to 1280x768 or 1366x768
Displays the H (Horizontal)IV (Vertical) frequencies.
@ Display range
Horizontal: 15- 110 kHz
Vertical: 48 - 120 Hz
PC
adjustments
26 ÷ Audio menu (p. 28)
To Next Page
Loading...
