Automaticallysearchesandaddsavailablechannelstothememory.
_1_Select "ANT in" _3_Select a scanning mode (p. 13)
_Select "Cable" or "Antenna"
or select "Not used" (p. 13).
_ Select "Auto program"
Settings are made automatically
@ After the scanning is completed, select "Apply".
(see below _5_).
@ All previously saved channels are erased.
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel list
manually.
You can select a channel tuning mode (Digital only/Analog
only) in "Channel surf mode"(p. 29)
_ Select "Edit"
@_Select the item to edit
Favorite
Caption Add
¼
R G
_Proceed to
next page
Go backtothe previous
page
® Caption:
Changes the station identifier
® Favorite:
Registers channels to the
Favorite List
® Add:
Adds or skips channels
Edit
@Caption
B m_4tLr_
_change or _ _
@set _#_
Select or edit the station identifier.
(maximum 7 characters available)
@ Favorite
select
_"_---_2)set
RETURN
1
Set favorite J Select the number
@ Add
RETURN
Press OK to select "Yes (add)" or "No (skip)" _)
@ Move the cursor to a channel number
@ Select "Apply"
To cancel the Edit
Checkthe signal strength if interference isfound or freezing occurs on a digital image.
BH_qm
BUm
BDD or
intensity @ Not available if "Cable" is selected in "ANT in" (see above).
@ Available only for digital antenna channels.
@If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
I
@
FR
£)..
m.
£)._
O3
,_-.
C)
::3"
"-I
¢D
O_
39
To Next Page
Loading...
