7
de
t
r
a
ts
g
ni
t
teG
●
y
rosseccA
lan
o
i
t
p
O
/s
e
i
rosseccA
Attaching the pedestal to TV
■
Assembling the pedestal
●
Fix securely with assembly screws
A
. (Total 4 screws)
●
Tighten screws firmly.
Accessories
Assembly screws (4 of each)
A
B
●
XSS5+16FNK size
(M5 x 16)
●
XYN4+F25FJK
size (M4 x 25)
Bracket (1)
●
TBL5ZA32151
Base (1)
A
Bracket
Front
Base
Make sure that the
bracket is anchored
before fixing the screws.
■
Set-up
●
Tighten assembly screws
B
(total 4 screws) loosely at
first, then tighten them firmly to fix securely.
Rear view
B
Rear side
Base
Bracket
Hole for pedestal
installation
Arrow
mark
Arrow mark
Work on a flat surface
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when
using the wall hanging bracket or repacking the TV.
1. Remove the assembly screws
B
from the TV.
2. Lift the TV from the pedestal.
3. Remove the assembly screws
A
from the bracket.
WARNING
Do not disassemble or modify the pedestal.
●
Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
●
Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
●
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic
dealer immediately.
During set-up, make sure that all screws are securely tightened.
●
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure.
(above)
●
Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.
To Next Page
Loading...
