Displaying PC Screen on TV
The screen of the PC connected to the unit can be displayed on the TV.
You can also listen to PC sound with the audio cable connected. To connect PC. (p. 43)
_ Display the Input select menuINPUT _ _,
4
5
6
7
8
Select "PC"
(example)
® Corresponding signals
(p.48)
INPUT
• To return to TV _ ®,,_1
Displays
PC screen
• PC menu setting (change as desired)
® Making settings ÷ "How to Use Menu Functions" @ to O (p. 27)
Menu Item t Adjustments/Configurations (options)
Resettodefaults Resets PC adjustments. Confirmation screen is displayed. Select "Yes" and press OK to reset.
® H & V: The H and V sync signals are input from the HD/VD connector. (p. 49)
Sync ® On green: Uses a synchronized signal on the Video G signal, which is input from the
G connector. (p. 49)
Dot clock Alleviates the problem if a picture appears to be vertically-striped, flickers partially or is blurred.
Adjusts the horizontal position.
H-position
Adjusts the vertical position.
V-position
PC
adjustments
Alleviates the problem if the whole picture appears to flicker or is blurred.
First adjust the Dot Clock to get the best possible picture, then adjust the
Clock Phase so that a clear picture appears.
Clock phase
It may not be possible to display a clear picture due to poor input signals.
Switches to wide display.
Input ® input signal switched from 640x480 to 852x480
resolution
® input signal switched from 1024x768 to 1280x768 or 1366x768
Displays the H (Horizontal)/V (Vertical) frequencies.
H-frequency ® Display range
V-frequency Horizontal: 15 - 110 kHz
Vertical: 48 - 120 Hz
® Audio menu (p. 28)
26
To Next Page
Loading...
