Panasonic Viera TC-P42GT25

9
Quick Start
Guide
Accessories/Optional Accessories
Accessories
Assembly screws
A
XYN5+F18FN
M5 × 18 (Silver) (3)
B
THEL080N (for 42”)
THEL079N (for 50”)
M5 × 30 (Black) (4)
Pole (1)
Base (1)
Attaching/Removing the pedestal
■
Assembling the pedestal
Fix securely with assembly screws
A
. (Total 3 screws)
Tighten screws firmly.
A
Front
Pole
Base
■
Set-up
Carry out work on a horizontal and level surface.
Tighten assembly screws
B
(total 4 screws) loosely at first,
then tighten them firmly to fix securely.
B
Rear side
Arrow
mark
Pole
Hole for pedestal
installation
Pole
Base
Bottom view
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV.
Remove the assembly screws
B
from the TV.
Pull out the TV from the pedestal.
Remove the assembly screws
A
from the pole.
Warning
Do not disassemble or modify the pedestal.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any other TV and displays.
Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic
Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (see above)
Otherwise the TV and/or pedestal may fall over and become damaged, and personal injury may result.
tcp4250GT25eng0594.indb9tcp4250GT25eng0594.indb9 2010/07/1415:47:522010/07/1415:47:52