• Assembling the pedestal
insert the protrusion of the Neck
into the Base firmly.
Front
Turn the stand over and fix stand neck
securely with assembly screws.
(for 42"/50": 3 screws, for 55": 4 screws)
• Do not hold the neck when turning over the stand.
/B_x 3 pcs. (for 42"/50")
B_x 4 pcs. (for 55")
[TC-P42UTS0,
[TC-P55UTS0]
_3_AttachtheBracketto the protrusionof Neck.
Makesurethat the bracketis anchored
beforefixingthescrews.
Fixsecurelywith assemblyscrews.(4 screws)
Protrusion of Neck (top) t._'_B_ ,'x 4 pcs.
@ Attach the cover and fix securely with
assembly screw.
._----_) x 1 pcs.
Cover
reSet-up
@ Tighten assembly screws _A_(for 42"/50") / _B_(for 55") (total 4 screws) loosely at first,
then tighten them firmly to fix securely.
Rear side
Accessories
Assembly screws
®
_ XYN4+F10FNK (Black)
size (M4 x 10)
(for 42"/50" (5), for 55" (1))
_ XYN5+F16FN (silver)
size (M5 x 16)
(for 42"/50" (7), for 55" (12))
Bracket (1)
_ TBL5ZA3238 (for 42"/50")
@ TBL5ZA3200 (for 55")
Neck (1)
(_ TXFBL5Z0069 (for 42"/50")
_:¢TXFBL5Z0085 (for 55")
Cover (1)
_ TXFBL5Z0071 (for 42"/50")
¢_ TXFBL5Z0056 (for 55")
@ Cover is in the same bag
with Owner's Manual
Base (1)
@ TBL5ZX0292 (for 42")
@ TBL5ZX0294 (for 50")
_9 TBL5ZX0420 (for 55")
for pedestal
installation
x 4 pcs. (for 42"/50")
x 4 pcs. (for 55")
Bracket
(Image) I Work on a flat surface ]
Do not disassemble or modify the pedestal.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using
the wall hanging bracket or repacking the TV.
Remove the assembly screws _A_(for 42"/50") / _ (for 55")
from the TV.
Lift the TV from the pedestal.
_3_Remove the assembly screw @ from the cover.
@ Pull out the cover.
Remove the assembly screws _B_from the Bracket.
Remove the assembly screws _B_from the Back of stand and
pull out the neck.
4_Otherwise, the TV may fall over and become damaged, and personal injury may result.
Caution )
Do not use any pedestal other than that provided with this TV.
@Otherwise, the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
@ Ifyou use the pedestal when it is physically damaged, personal injury may result.Contact your nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
_Dif sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (Above)
® Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.
9
To Next Page
Loading...
