Tuning and Editing Channels
31
Set Analogue channel manually [Analogue Manual Tuning]
Set Analogue channel manually after Automatic Channel Search.
Example: Antenna
Analogue Manual Tuning
Searching Channels
Scan up Scan down
Start Frequency (MHz) 48.00
1 Enter the frequency to start scanning
[Scan up]: Scans ascendingly from the entered
frequency to higher frequencies
[Scan down]: Scans descendingly from the entered
frequency to lower frequencies
2 Select the scanning method
Select
Access
Check DVB-T signal condition [DVB-T Signal Condition]
Example:
DVB-T Signal Condition
Signal Level
Channel
Bit Error Rate
Signal Condition
10
0.00E-06
96
91
These bars show the maximum signal value of the
selected channel.
Set DVB channel manually [DVB-T Manual Tuning]
Normally use [Automatic Channel Search] or [Scan] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
●
All channels found will be added to the Channel List.
DVB-T Manual Tuning
Channel
Scan
Signal Condition
Signal Level
10
0%
100
100
Antenna
Change
Access
List favourite DVB channels [Favourites Edit], Skip unwanted channels [Skip]
Create your favourite channel lists from various broadcasters.
1 Select a channel to list ( : Encrypted channel)
Favourites Edit
1 Analogue
3 Digital
2 Analogue
4 Digital
Select
Add / Remove
: Add
: Remove
■ Skip unwanted channels [Skip]
You can hide unwanted channels.
The hidden channels cannot be displayed except in this function. Use this function to skip unwanted channels.
Select a channel and reveal / hide
Skip
1 Analogue
3 Digital
2 Analogue
4 Digital
Access
Select
: Hide (skip)
: Reveal
●
To change page (page up)
●
To change page (page down)
●
To select
●
To exit
TH-L32_39EM5A_EN.indb 31TH-L32_39EM5A_EN.indb 31 7/27/2012 5:28:42 PM7/27/2012 5:28:42 PM
To Next Page
Loading...
