32
Off
DVB Signal Condition
DVB Programme [70] CBBC Channel
0 5 10
Signal Quality
Signal Strength
Selects a channel and checks the DVB signal condition.
Use for adjusting the direction of the aerial.
Signal Quality:
•
Green bar Good
•
Yellow bar Poor
•
Red bar Bad (Check the aerial)
•
To change the programme during the menu appears
Check
DVB signal
DVB Signal
Condition
Display a
notification
message
New DVB Service Found!
Press OK to start Auto Setup
Press EXIT to lgnore.
Selecting Auto Setup will delete
current Profile and Childlock settings
Selects whether to give a notification message when a new DVB service is found. (Off / On)
•
Selecting OK (Auto Setup) will delete
current Profile and Childlock settings.
New Service
Message
Add
DVB channel
automatically
Any new services found will be added to the DVB Service List (p. 29) automatically.
ADD New DVB Services
Please wait
This will take about 3 mins.
21 68
Prog. Channel Service Name Net ID. TS ID. Quality
ZDF
ARD
start
•
The new service is added with the current
settings saved as they are.
Add New
DVB Services
Set DVB
channel
manually
DVB Manual
Tuning
select channel
search
DVB Manual Tuning
Signal Quality
Stopped
010
Signal Strength 010
Frequency MHz
[
CH21
]
474,00
Prog. Channel Net ID. QualityTS ID.Service Name
Normally use “Auto Setup” or “Add New DVB Services” for the DVB channel setting.
If tuning has not done completely, use this function.
•
All services found will be added to the
DVB Service List (p. 29) automatically.
Set Analogue
channel
manually
Analogue
Manual Tuning
Programme 1 BBC1 [CH33]
Analogue Manual Tuning
Manual Tuning 21 68
Set Analogue channel manually after Auto Setup.
If a VCR is connected with only the RF cable, select programme position “0”.
store
search
Select the channel Search and storeSelect the programme position
VCR
132
465
798
0
Tuning Channels
To Next Page
Loading...
