Accessories / Options
Quick Start Guide
7
Attaching the pedestal
Warning
Do not disassemble or modify the pedestal.
•
O therwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than the one provided with this TV.
•
O therwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
•
If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest Panasonic dealer
immediately.
During assembly, use only screws supplied and make sure that all screws are securely tightened.
•
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough
to support the TV. It might fall over and become damaged and personal injury may result.
Ensure that the TV does not fall over.
•
If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over and personal injury may
result.
Two or more people are required to install and remove the TV.
•
If two or more people are not present, the TV may be dropped, and personal injury may result.
A
Assembly screw (4)
M5 × 15
B
Assembly screw (4)
M4 × 30
C
Bracket
•
TBL5ZA3017
()
TX-L32E30E
TX-L37E30E
•
TBL5ZA3014
(TX-L42E30E)
D
Base
•
TBL5ZX0140 (TX-L32E30E)
•
TBL5ZX0144 (TX-L37E30E)
•
TBL5ZX0149 (TX-L42E30E)
1
Assembling the pedestal
U se the assembly screws
A
to fasten the bracket
C
to the base
D
securely.
•
M ake sure that the screws are securely
tightened.
•
F orcing the assembly screws the wrong way
will strip the threads.
A
D
C
Front
H old the bracket not to
fall over
2
Securing the TV
U se the assembly screws
B
to fasten securely.
•
T ighten the four assembly screws loosely at first, then tighten
them firmly to fix securely.
•
C arry out the work on a horizontal and level surface.
B
B
F oam mat or thick soft cloth
Installing / removing remote’s batteries
1
Pull open
H ook
Caution
•
I ncorrect installation may cause battery leakage and corrosion, resulting
in damage to the remote control.
•
D o not mix old and new batteries.
•
R eplace only with same or equivalent type. Do not mix different battery
types (such as alkaline and manganese batteries).
•
D o not use rechargeable (Ni-Cd) batteries.
•
D o not burn or break up batteries.
•
D o not expose batteries to excessive heat such as sunshine, fire or the like.
•
M ake sure you dispose of batteries correctly.
•
E nsure batteries are replaced correctly, there is danger of explosion and
fire if battery is reversed.
•
D o not disassemble or modify the remote control.
2
N ote the correct
polarity (+ or -)
Close
To Next Page
Loading...
