Accessories / Options
7
Quick Start Guide
Attaching the pedestal
To help avoid risk of damage or injury by the TV tipping or falling, please follow the warnings and cautions below:
Warning
t
Do not disassemble or modify the pedestal.
Caution
t
Do not use any pedestal other than the one provided with this TV.
t
Do not use the pedestal if it becomes warped or physically damaged. If this occurs, contact your nearest Panasonic dealer
immediately.
t
During setup, make sure that all screws are securely tightened.
t
Ensure that the TV does not suffer any impact during installation of the pedestal.
t
Ensure that children do not climb onto the pedestal.
t
Install or remove the TV from the pedestal with at least two people.
A
Assembly screw (4)
t
XSS5+15FNK
M5 × 15
B
Assembly screw (4)
t
XYN4+F30FJK
M4 × 30
C
Bracket
t
TBL5ZA3017
(TX-L32E3B)
(TX-L37E3B)
t
TBL5ZA3014
(TX-L42E3B)
D
Base
t
TBL5ZX0041
(TX-L32E3B)
t
TBL5ZX0039
(TX-L37E3B)
t
TBL5ZA0147
(TX-L42E3B)
1
Assembling the pedestal
Use the assembly screws
A
to fasten the
bracket
C
to the base
D
securely.
t
Make sure that the screws are securely
tightened.
t
Forcing the assembly screws the wrong
way will strip the threads.
A
D
C
Front
2
Securing the TV
Use only the supplied assembly screws
B
to fasten the pedestal
securely to the TV.
t
Tighten the four assembly screws loosely at first, then tighten
them firmly to fix securely.
t
Carry out the work on a horizontal and level surface.
B
B
Foam mat or
thick soft cloth
Installing / removing remote’s batteries
1
Pull open
Hook
2
Note the correct
polarity (+ or -)
Close
Caution
t
Incorrect installation may cause battery leakage and corrosion, resulting in damage to the remote control.
t
Do not mix old and new batteries.
t
Replace only with same or equivalent type. Do not mix different battery types (such as alkaline and manganese batteries).
t
Do not use rechargeable (Ni-Cd) batteries.
t
Do not burn or break up batteries.
Batteries must not be exposed to excessive heat such as sunshine, fire, etc.
t
Make sure you dispose of batteries correctly.
t
Ensure batteries are replaced correctly, there is danger of explosion and fire if battery is reversed.
t
Do not disassemble or modify the remote control.