Panasonic VL-SV72 - Page 2

Specications
Model Composition
Model number and name
VL-MV71
VL-MV72
VL-PS241
(VL-MV72 only)
VL-V522L
Main Monitor Station (Main monitor)
Extension Monitor
Power supply unit Door Station (Doorphone)
Dimensions
(mm)
Up to 3
(not including the main monitor)
Up to 2
99
131
36.5
Power source
VL-MV71: 220-240 V AC, 50/60 Hz
VL-MV72: Power supply unit (VL-PS241)
24 V DC, 0.4 A
Input: 220-240 V AC, 0.2 A, 50/60 Hz
Output: 24 V DC, 0.6 A
Power supplied by the main monitor
Power consumption
VL-MV71: Standby: Approx. 2.0 W
During operation: Approx. 10.5 W
VL-MV72: Standby: Approx. 1.6 W
During operation: Approx. 9.8 W
- -
Dimensions (H x W x D)
(Excluding protruding sections)
158 x 243 x 29.5 mm 104 x 100 x 54 mm 131 x 99 x 36.5 mm
Weight
VL-MV71: 835g
VL-MV72: 710g
215 g 200 g
Operating environment
Ambient temperature: Approx. 0 °C to +40 °C
Relative humidity (non-condensing): up to 90 %
Ambient temperature: Approx. 0 °C to +50 °C
Relative humidity (non-condensing): up to 90 %
Ambient temperature: Approx. -15 °C to +55 °C
Relative humidity (non-condensing): up to 90 %
(tested up to -20 °C)
Display 7-inch wide colour / WVGA (800 x 480 pixels) - -
Display language English, Arabic - -
Talking method Hands-free - -
Viewing angle - -
Horizontally: Approx. 87˚
Vertically: Approx. 66˚
Installation method
Wall mount
(mounting bracket supplied)
Wall mount or attach to DIN rail Surface mount (mounting base supplied)
Minimum illuminance required - -
1 lx
(within approx. 50 cm from the camera lens)
Lighting method - - Warm white coloured LED lights, Infrared LEDs
Transmitting range - - -
IP rating / IK rating - - IPX3
*
External material
Flame retardant PC+ABS resin,
Flame retardant ABS resin
Flame retardant PC+ABS resin Flame retardant ABS resin
243
158
29.5
VL-SV71 VL-MV71 x 1, VL-V522L x 1
VL-SV72 VL-MV72 x 1, VL-V522L x 1, VL-PS241 x 1
Installing the Main Monitor/Extension Monitor
Installing the Doorphone
Important
– Safety Precaution: carefully read the operating instructions and installation manual before using this product.
• The actual product may vary slightly from photograph.
• Weights and dimensions are approximate.
• Design and Specifications are subject to change without notice.
• These products may be subject to export control regulations.
* Water resistance is only assured if the doorphone is installed correctly according to the instructions in the Installation Guide, and appropriate water protection measures are taken.
Vertical, at wall
Screws
Hole in wall
83.5 mm
60 mm
7 mm
50 mm
Mounting bracket
Wood screws
Mounting base
Wire
(User supplied)
Screwdriver
83.5 mm
Wall
Side View Top View
131 mm
99 mm
Mounting
base
24 mm
83.5 mm
Image range
Centre of
doorphone
1450 mm
650 mm
1810 mm
1160 mm
500 mm
66°
87°
500 mm
960 mm
•Installation Position
DISTRIBUTED BY :
MG-DHPL021EN 1705TD/ZZZ-AU1
158 mm
243 mm
Mounting
bracket
Main
Monitor
58 mm
83.5 mm
Installing the Power Supply Unit
AC cable
DC cable
Remove the screw
on the cable cover.
Top View
AC IN connector
100
104
54
Front View
DC OUT
terminal
DC cable
binder hole
Bottom View
25 mm
7 mm
DC Cable