Installing the door station
(VL-V554UEX)
Install the flush mounting box in the wall.
Use a hex wrench to loosen screw A and
remove the front panel of the door station.
Front panel
Screw A
2 mm hex wrench
Connect the wires
<Rear view>
Terminal for the
electric lock
Terminal for the
main monitor station
1 Loosen the screws.
2 Push in the wires to the terminal connectors
(non-polar), then tighten the screws.
151mm
Flush mounting box
Knockout hole
*1
100mm
37mm
*1 Only open the knockout holes as required for
the wiring.
Step 1
Step 2
Step 3
Door Station
Door Station
Installation
Installation
To Next Page
Loading...
