Screws x 2 *
Mounting base
Wire
83.5
mm
Wall
Installing the door station
(VL-V554EX)
Attach the mounting base to the wall
securely.
Use a hex wrench to loosen screw A and
remove the front panel of the door station.
Front panel
Screw A
2 mm hex wrench
Connect the wires
<Rear view>
Terminals for the
electric locks
Terminal for the
main monitor station
1 Loosen the screws.
2 Push in the wires to the terminal connectors
(non-polar), then tighten the screws.
•Install the mounting base on a vertical flat wall.
Step 1
Step 2
Step 3
To Next Page
Loading...
