Panasonic VL-V591 - Programming Room Numbers; Registering Room Numbers; Confirming Room Numbers; Canceling Room Number Registration

13
Programming
Conrming a room number
1 Press and hold the PROGRAM switch for about 2
seconds during standby.
2 Enter {0}{0}{2}, then press {CALL}.
3 Enter the desired terminal number (001-020) (in 3
digits), then press {CALL}.
LThe terminal number and the room number are
displayed alternately.
LTo conrm another room number, press {CALL}, then
repeat this step.
4 When nished, press {CLR}.
5 To end programming mode, enter {9}{9}{9}, then press
{CALL}.
Conrming all room numbers
1 Press and hold the PROGRAM switch for about 2
seconds during standby.
2 Enter {0}{0}{3}, then press {CALL}.
LThe terminal number 01 and the room number are
displayed alternately.
3 To conrm the next room number, press {CALL}.
LThe next terminal number and the room number are
displayed.
4 When nished, press {CLR}.
5 To end programming mode, enter {9}{9}{9}, then press
{CALL}.
Canceling the registration of a room number
1 Press and hold the PROGRAM switch for about 2
seconds during standby.
2 Enter {0}{0}{4}, then press {CALL}.
3 Enter the desired terminal number (001-020) (in 3 digits)
for the room number to be erased, then press {CALL}.
L“dEL” and the terminal number are displayed
alternately.
4 Press {CALL} to cancel the registration.
LTo delete another room number, repeat from step 3.
5 To end canceling the registration, press {CLR}.
6 To end programming mode, enter {9}{9}{9}, then press
{CALL}.
Canceling the registration of all room numbers
1 Press and hold the PROGRAM switch for about 2
seconds during standby.
2 Enter {0}{4}{4}, then press {CALL}.
L“ALL” and “dEL” are displayed alternately.
LTo stop deleting numbers, press {CLR}.
3 Press {CALL} to cancel the registration.
4 To end programming mode, enter {9}{9}{9}, then press
{CALL}.
Registering room numbers
Register each room number to each terminal number (01-20) (page 10).
1 Press and hold the PROGRAM switch for about 2 seconds during standby.
2 Enter {0}{0}{1}, then press {CALL}.
3 Enter the desired terminal number (001-020) (in 3 digits), then press {CALL}.
LTo correct the number, press {CLR}, then repeat this step.
4 Enter the desired room number (within 3 digits), then press {CALL}.
LThe terminal number and room number are displayed alternately.
LTo correct the number, press {CLR}, then repeat from step 3.
L“Err” (Error) is displayed when a registered room number is entered. Press {CLR}, then repeat from step 3.
5 Press {CALL} again to save the setting.
LAfter the room number is registered, the display on the right is shown.
LTo register other room numbers, repeat steps 3 to 5.
LTo conrm the room numbers, press {CLR}, then continue from step 2 of
“Conrming all room numbers” below.
6 To end the registration, press {CLR}.
7 To end programming mode, enter {9}{9}{9}, then press {CALL}.
NTo change a room number
Enter the new room number in step 4. The previous room number is replaced with the new one.
VL-V591_IG_en.indd 13 2017/09/22 19:03:00