14
Programming
Setting the time how long the door remains open
You can select how long the door of the common entrance remains open when the PIN is entered on the lobby station. The
default setting is “5” (5 seconds).
LAfter connecting the door opener to the lobby station (page 9), conrm that the door can be properly locked/unlocked using
the PIN depending on the status of the door opener (page 15). If your door opener automatically locks the door when it is
closed, we recommend selecting “2” (2 seconds).
1 Press and hold the PROGRAM switch for about 2 seconds during standby.
2 Enter {0}{0}{6}, then press {CALL}.
3 Select the time (2 seconds to 7 seconds) by entering 2 to 7.
4 Press {CALL}.
LWhen “Err” (Error) is displayed, press {CLR}, then start from step 2.
5 To end programming mode, enter {9}{9}{9}, then press {CALL}.
Setting the PIN (Personal Identication Number)
When a separate door opener is connected to the lobby station, the PIN is used to open the door of the common entrance.
The default PIN is “0000” (the feature is deactivated). Once you change the PIN, the door can be opened using the PIN.
1 Press and hold the PROGRAM switch for about 2 seconds during standby.
2 Enter {0}{0}{5}, then press {CALL}.
3 Enter the 4-digit PIN (0001-9999).
LTo correct the number, press {CLR}, then start from step 2.
4 Press {CALL}.
LWhen “Err” (Error) is displayed, press {CLR}, then start from step 2.
5 To end programming mode, enter {9}{9}{9}, then press {CALL}.
NTo change the PIN again
Enter the new PIN in step 3. The old PIN is replaced with the new one.
NTo return to the default setting
Enter “0000” in step 3. (The feature is deactivated.)
Note:
LTake the following measures to avoid security breaches.
– To prevent unauthorized access to this unit, change the PIN regularly.
– Keep the PIN condential.
– Select a complex, random PIN that cannot be easily guessed.
VL-V591_IG_en.indd 14 2017/09/22 19:03:00
To Next Page
Loading...
