1 2
1. Including Items
The following items are included in addition to the lobby station.
Embedded box:
Trepanning a hole on the wall, insert
the embedded box, and fix it with the
cement slurry.
1
1
1
1
1
1
1
8
4
1
NamePart
Count
2 wire connector: AWG22, for power
port.
2 wire connector: AWG24, for 12V outp-
ut port.
2 wire connector: AWG26, for 485 port.
3Wire connector: AWG24, for lock port.
8Wire connector: AWG26, for OpenDo-
or/DoorState/FireAlarm port.
Screwdriver
Screw M4*8 & Gasket: Locked the Out-
door unit to the embedded box.
(Only four screws are used, and
the other four are spare)
Screw ST5.5*25: Lock the embedded
box to the wall.
Spong Pad: Paste to the embedded box
if the anti-movement button can not
touch to the embedded box.
2. Important Information
2.1 Important Safety Information
To prevent severe injury or loss of life or property, and to ensure
proper and safe operation of your product, read this section care-
fully before using the product.
WARNING
Preventing fire, electric shock, and short circuits.
・ Leave installation work to the dealer. Installation work requires
technical knowledge and experience. Electrical connection work
should be performed by certified personnel only. Failure to obs-
erve this may cause fire, electric shock, injury, or damage to the
product. Consult the dealer.
・ Use only the power supply unit VL-PC3400.
・ Do not place objects on the power cables. Install the product
where no one can step or trip on the power cables.
・ Do not allow the power cables to be excessively pulled, vent or
placed under heavy objects.
・ Make sure all connections from the power outlet to the power
supply unit are secure.
・ Never touch the power supply unit and power cables with wet
hands.
・ Do not use the power supply unit for outdoor installations (it is
for indoor use only).
・ Do not disassemble or modify the product. Refer servicing to an
authorised service centre when service is required. Disassem-
bling the product or manipulating the product in a way not desc-
ribed in the documentation may expose you to dangerous volta-
ges and other risks.
・ Do not touch the product or the power supply unit during an ele-
ctrical storm. There may be a remote risk of electric shock from
lightning.
To Next Page
Loading...
