Panasonic WH-UD07JE5 - Page 75

75
12.2.4.2 Wire Stripping and Connecting Requirement
W
ir
e
stripping
5mm or
more
(gap between
wires)
No loose strand
when insert
Indoor/outdoor
connecting
terminal board
10 ± 1mm
ACCEPT PROHIBITED
Conductor
over insert
Conductor not
fully insert
Conductor
fully insert
PROHIBITE D
12.2.4.3 Connecting Requirement
For Tank Unit with WH-UD03JE5, WH-UD05JE5, WH-UD07JE5, WH-UD09JE5
 The equipment’s Power Supply 1 complies with IEC/EN 61000-3-2.
 The equipment’s Power Supply 1 complies with IEC/EN 61000-3-3 and can be connected to current supply
network.
 The equipment’s Power Supply 2 complies with IEC/EN 61000-3-2.
 The equipment’s Power Supply 2 complies with IEC/EN 61000-3-11 and shall be connected to suitable supply
network, with the following maximum permissible system impedance Z
max
= 0.352 ohm (Ω) at the interface.
Please liaise with supply authority to ensure that the Power Supply 2 is connected only to a supply of that
impedance or less.
12.2.5 Charging and Discharging the
Water
 Make sure all the piping installations are properly
done before carry out below steps.
12.2.5.1 Charge the Water
 For Domestic Hot Water Tank
1 Set the Domestic Hot Water Tank Discharge
(Drain Tap)
to “CLOSE”.
”NEPO“”ESOLC“
D
o
m
e
stic H
o
t
W
a
t
e
r
T
a
nk
D
isch
a
r
g
e
(
D
r
a
in
T
a
p
)
g
2 Set all Tap / Shower “OPEN”.
3 Start filling water to the Domestic Hot Water
Tank via Tube Connector
c
.
After 20~40min, water should flow out from
Tap / Shower. Else, please contact your local
authorized dealer.
4 Check and make sure no water leaking at the
tube connecting points.
 For Space Heating / Cooling
1 Turn the plug on the Air Purge Valve outlet
anticlockwise by one complete turn from fully
closed position.
Plug (turn
anticlockwise by
one complete turn)
Air purge valve
2 Set the Pressure Relief Valve lever “DOWN”.
Lever
Turn down
or
Lever
Turn down
Pressure relief valve
Pressure relief valve
Pressure relief valve Pressure relief valve
3 Start filling water (with pressure more than
0.1 MPa (1 bar)) to the Space Heating /
Cooling circuit via Tube Connector
a
. Stop
filling water if the free water flow through
Pressure Relief Valve Drainage
.
4 Turn ON the Tank Unit and make sure Water
Pump is running.
5 Check and make sure no water leaking at the
tube connecting points.