FV-MSVK1 Motion Sensor module turns the base fan on or boosts to higher
speed when motion is detected when used in combination with the FV-VS15VK1.
The Motion Sensor is pre-set to run for 20 minutes; it will then re-check for
movement; if detected, the fan will run for another 20 minutes cycle. The Motion
Sensor detects within the range shown below.
WP100PBA Swidget Wi-Fi control module
Wi-Fi Plug 'N Play™ features
• Wireless Plug 'N Play™ control module for Panasonic WhisperGreen Select .
• Connect and control Panasonic ventilation products with the Swidget iOS or
Android app through 2.4 GHz Wi-Fi.
• Connect, group and balance Panasonic ventilation products with a dedicated
Swidget commissioning iOS or Android application through Bluetooth 5.0 mesh.
Swidget app features
• Control the boost mode of all compatible Panasonic ventilation products with
an always-ON or 20-40-60 minute timer.
• Control the light module and view the motion and condensation module status
of compatible Panasonic WhisperGreen Select models.
• View the supply air and exhaust air CFM, temperature and humidity of compat-
ible Panasonic ventilation products.
• Receive notifications for faults, filter replacement and filter cleaning for
compatible Panasonic ventilation products.
• Monitor the energy consumption of compatible Panasonic ventilation products.
This module must only be installed and used with an approved/certified Swidget
wiring device. Usage with any other devices is not permitted and will result in the
warranty becoming void.
• While not required, it is recommended to avoid any risk of shock or death, turn
off power at the circuit breaker or fuse and test that the power is off before
installing or removing any module.
• Not for use to control medical or life support equipment.
• For INDOOR use only: 0°C - 40°C (32°F - 104°F).
• Module can only be installed in one orientation. Rear alignment pins prevent
incorrect installation. Do not forcibly install an module.
• Requires a wireless router and Internet connection for device setup.
• Double check any external Wi-Fi settings for accuracy before using them.
• Actual wireless performance in a home depends on the numbers of walls /
obstacles between the module and wireless router.
SCAN QR CODE FOR Wi-Fi
MODULE’S INSTRUCTION
OR VISIT WEB SITE
9
1115 MODEL
0511 MODEL
®
®
®
INDICATIONS (Plug 'N Play™ FUNCTION DEVICES)
Note.- There are TWO
Plug 'N Play™ slots to insert
the motion sensor module. See
page 10 for detail.
The distance that motion can be
detected is limited to 10 feet (3 m).
The field of view of the sensor is 90º
.
Room temperature is 77 ºF (25 ºC).
http://WP100PBA-QR.swidget.com
www.swidget.com
WARNING
NOTICE
To Next Page
Loading...
