Panasonic WV-CP410 - Video Cable and Wiring Precautions

C. WV-CP414 Video Cable
1. A power supply of 24V AC 50Hz is required. 1. It is recommended to use a video monitor whose
2. Connect the power cable to the AC 24V In resolution is at least equal to the camera's resolu-
Terminal (19) on the rear panel of the camera. tion..
2. Terminate the camera output with 75-ohm resistor
at the furthest end of its cable run.
A. Use 75-ohm coaxial cable.
B. Always set the last monitor's termination
switch to 75 ohms, and set the termination
switches of intermediate monitors to HIGH (Hi-
Z) position.
AC 24 N
24 VAC, 50 Hz
(19.5 V - 28 V)
Monitor Monitor
Recommended wire gauge sizes for 24V AC line.
Copper wire #24 #22 #20 #18
size (AWG) (0.22mm%) | (0.33mm?) | (0.52mm?) | (0.83mm?)
Length (ft) 314 495 | 842 1403
of Cable | ; i i
(Approsy LcUn) 96 150 L 256 | 496 C. The maximum extensible coaxial cable length
between the camera and the monitor is shown
in the table 1.. Since cable quality varies
among manufactures, please verify video
quality before final installation, if maximum
lengths are to be used.
40+