57
Set the VMD areas [VMD area]
Click the [VMD area] tab on the "Alarm setup" page. (☞ pages 20 and 21: How to display/operate the setup menu)
The video motion detection areas can be set on this page.
The VMD areas can be set for each preset position (up to 64 areas). When motion is detected in the set area, the
alarm action will be performed. The camera can be configured to take an alarm action even when the camera is not
at the preset position.
Important:
• Areas used for the time and date display of "OSD position" (☞ page 25) cannot be used for the VMD areas.
• It is possible to display the alarm occurrence indication button on the [VMD area] tab when motion is detected by
the VMD function. Select "ON" for "VMD alarm" on the [Alarm] tab when the alarm occurrence indication button is
to be displayed.
• The alarm occurrence indication button will be displayed when receiving an alarm input of a terminal alarm or a
command alarm.
• Depending on the network environment, notification may be delayed even when "Real time" is selected for
"Alarm status update mode" on the [Basic] tab of the "Basic setup" page (☞ page 25).
Areas used for the time and date display of "OSD position"
To Next Page
Loading...
