4. Click the divided areas to be masked.
→ The clicked areas will be masked and will become white. To cancel masking, click the area again.
5. Click the [End] button after completing masking areas.
→ The borders on the image displayed on the [Image quality] tab will disappear.
IMPORTANT
• The mask area may move out of alignment when “Image capture mode” of the [Image] tab is changed.
Make sure to check the mask area after changing the “Image capture mode” setting.
• The mask area may move out of alignment when “Extra optical zoom” is configured. Make sure to
check the mask area after configuring “Extra optical zoom”.
Note
• When the [Reset] button is clicked, masking for all the masked areas will be canceled.
108 Operating Instructions
2 Settings
To Next Page
Loading...
