2.5.2 Configure the settings relating to JPEG images [Image]
Click the [Image] tab on the “Image/Audio” page. (®page 41, page 42)
“Live” page (Initial display)
Configure the settings relating to the initial images displayed on the “Live” page.
[Initial display stream]
Select the image to display on the “Live” page from the following.
Stream(1)/Stream(2)/Stream(3)/Stream(4)/JPEG(1)/JPEG(2)/JPEG(3)/Multi-screen
• Default: Stream(1)
Note
• When “JPEG(1)”, “JPEG(2)”, or “JPEG(3)” is selected, the refresh interval can be selected.
MJPEG/Refresh interval: 1s/Refresh interval: 3s/Refresh interval: 5s/Refresh interval: 10s/Refresh
interval: 30s/Refresh interval: 60s
[Refresh interval (JPEG)*]
Select an interval to refresh the displayed JPEG image from the following.
0.1fps/0.2fps/0.33fps/0.5fps/1fps/2fps/3fps/5fps/6fps* /10fps*/12fps*/15fps*/30fps*
• Default: 5fps
Note
• When “On” is selected for “Stream transmission”, the refresh interval may be longer than the set value
when any value with an asterisk (*) on the right is selected.
• Depending on factors such as the network environment, the resolution, the image quality, or the number
of computers concurrently accessing the camera, the transmission interval may be longer than the set
value.
• If images are not delivered in the specified transmission interval, you can make the images be delivered
closer to the specified time by lowering the resolution or image quality.
JPEG
Configure the settings such as “Image capture size”, “Image quality” of “JPEG(1)”, “JPEG(2)”, and
“JPEG(3)” on this section. Refer to page 89 for further information about the settings relating to H.265 (or H.
264) images.
Operating Instructions 87
2 Settings
To Next Page
Loading...
