Panasonic WV-SC385PJ - Page 20

Wire without making a hole in the ceiling
Step 1
Install the camera by following step 1 and steps 3 - 8 of the
"Wire through a hole in the ceiling" section (☞ pages 16 - 18). It
is unnecessary to make a hole in the ceiling as described in step
2 of the "Wire through a hole in the ceiling" section.
Step 2
Remove the tab on the rear of the decorative cover (accessory)
that is blocking the wiring hole.
Attach the decorative cover by following step 9 of the "Wire
through a hole in the ceiling" section (☞ page 19).
Wire through the wiring hole of the decorative cover.
Place the camera upside-down by fixing on the bracket
SC385
When using the camera upside-down, fix the camera using the camera mount bracket (accessory) to prevent a fall. If nec-
essary, attach the decorative cover (accessory) to the camera.
Install the camera by following step 1 and steps 3 - 9 of the "Wire through a hole in the ceiling" section (☞ pages 16 - 19).
When using the camera upside-down, select "On (desktop)" for "Upside-down" on the [Cam. Function] tab of the setup
menu. (☞ Operating Instructions (PDF))
Important:
 • Preparefourfixingscrews(M4orM6)tobeusedtomountthecameramountbracket(accessory)accordingtothe
material of the place where the camera mount bracket is to be installed.
LOCK
OPEN
OPEN
LOCK
WV-SC385
20