Panasonic WV-SF135 - Check the Status [Status]

4. Click the [Execute] button.
→ The confirmation window will be displayed. When “Do not reset the settings to the default after the
upgrade.” is selected, the confirmation window will not be displayed.
IMPORTANT
• After completing the upgrade, delete temporary internet files. (®page 157)
• Upgrade the firmware using a PC in the same subnet as the unit.
• Follow the instructions from the dealer when upgrading the firmware.
• When upgrading the application software, use the designated file (extension: img) for the firmware
upgrade.
The name of the firmware to be used for the upgrade should be “model name (Use small letters.
“WV” is not required.)_xxxxx.img”.
* (“xxxxx” indicates the version of the firmware.)
• Do not turn off the power of the camera during the upgrade process.
• Do not perform any operation during upgrading and wait until it completes.
• The following network settings will not be reset when upgrading the firmware after selecting “Reset the
settings to the default after completing the upgrade. (Except the network settings)”.
On/Off for DHCP, IP address, subnet mask, default gateway, HTTP port, HTTPS port, connection
protocol (HTTP/HTTPS), CRT key, server certificate, UPnP setting, line speed, bandwidth control (bit
rate), time & date
• The viewer software used on each PC should be licensed individually. Refer to your dealer for the
software licensing.
19.3 Check the status [Status]
Click the [Status] tab of the “Maintenance” page. (®page 32, page 34)
The status of this camera can be checked on this page.
Operating Instructions 151
19 Maintenance of the camera [Maintenance]