11.11 Configure the settings relating to audio
[Audio]
Click the [Audio] tab on the “Image/Audio” page. (®page 40, page 42)
The settings relating to audio can be configured on this page.
Note
• Images and audio will not be synchronized. Therefore, images and audio may not always match.
• Audio may be interrupted depending on the network environment.
• Recording will stop if the settings of audio are configured during recording.
[Audio transmission/reception]
Select the communication mode used for audio data transmission/reception between the camera and the PC
from the following.
• Off:
Does not receive/transmit audio between the camera and the PC. Therefore, the
settings and controls relating to audio will be invalidated.
• Mic input:
The PC receives audio data from the camera. Audio can be heard with
images on the PC. Images and audio will not be synchronized.
• Audio output:
Audio data from the PC will be transmitted to the camera. Audio can be heard
from the speaker connected to the camera.
• Interactive(Half-duplex):
Both reception and transmission are available. However, audio data
cannot simultaneously be transmitted and received.
• Interactive(Full-duplex):
Both reception and transmission are simultaneously available.
• Default: Off
Note
• Howling may be generated depending on usage conditions. If howling is generated, prevent sound
generated by the PC from entering the PC microphone.
• When “Multicast” is selected for “Transmission type” on the [JPEG/H.264] tab of the “Image/Audio”
page, audio transmission will become unavailable while monitoring H.264 images. To transmit audio
from a PC to the camera, click the [JPEG] button on the “Live” page.
• “Audio recording” and “Audio detection” only operate when “Mic input” or “Interactive(Full-duplex)” is
selected for “Audio transmission/reception”.
106 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
