Note
• When “Name w/time&date” is selected, the file name will be [“Entered file name” + “Time and date
(year/ month/ day/ hour/ minute/ second)” + “Serial number (starting from 00)”] + “s” during summer
time.
[Transmission interval]
Select the interval for the FTP periodic image transmission from the following.
1s/ 2s/ 3s/ 4s/ 5s/ 6s/ 10s/ 15s/ 20s/ 30s/ 1min/ 2min/ 3min/ 4min/ 5min/ 6min/ 10min/ 15min/ 20min/ 30min/
1h/ 1.5h/ 2h/ 3h/ 4h/ 6h/ 12h/ 24h
• Default: 1s
[Image capture size]
Select the image capture size of images to be transmitted from the following.
JPEG(1)/JPEG(2)/JPEG(3)
• Default: JPEG(2)
[FTP server address]
Enter the IP address or the host name of the FTP server.
• Available number of characters: 1 - 128 characters
• Available characters: Alphanumeric characters, the colon (:), the period (.), the underscore (_), and the
hyphen (-).
IMPORTANT
• When entering the host name for “FTP server address”, it is necessary to configure the DNS settings
on the [Network] tab of the “Network” page. (®page 139)
[User name]
Enter the user name (login name) to access the FTP server.
• Available number of characters: 1 - 32 characters
• Unavailable characters: " & : ; \
[Password]
Enter the password to access the FTP server.
• Available number of characters: 0 - 32 characters
• Unavailable characters: " &
[Control port]
Enter a control port number to be used for the FTP server.
• Available port number: 1-65535
• Default: 21
The following port numbers are unavailable since they are already in use.
20, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[FTP mode]
Select “Passive” or “Active” for the FTP mode.
Normally, select “Passive”. When it is impossible to connect after select “Passive”, try to connect after selecting
“Active”.
• Default: Passive
Operating Instructions 149
16 Configuring the network settings [Network]
To Next Page
Loading...
