Panasonic WV-SP305 - Page 27

27
When using 12 V DC power supply*
q Loosen the screw of the power cord plug (accessory).
w Connect the cable of the 12 V DC power supply* to the
power cord plug.
Strip 3 mm to 7 mm {1/8" to 9/32"} from the end of the
wire, and twist the stripped part of the wire sufficiently to
avoid short circuit.
Specification of cable (wire): 16 AWG - 24 AWG,
Single core, twisted
 • Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug.
r Connect the power cord plug to the 12 V DC power sup-
ply terminal on the rear of the camera.
* FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC
CLASS 2 POWER SUPPLY.
Important:
 • Besuretousethepowercordplugprovidedwiththisproduct.
 • Besuretofullyinsertthepowercordplugintothe12VDCpowersupplyterminal.Otherwise,
it may damage the camera or cause malfunction.
 • Wheninstallingthecamera,make sure that excessive force is not applied to the power cable.
 • Besure to use an AC adaptor compliant with the Specifications regarding power source and
power consumption (
☞ p.32).
When using PoE (IEEE802.3af compliant)
Connect a LAN cable (category 5 or better, straight, STP*) between a PoE device (such as a hub)
and the network connector of the camera.
* PAL models only.
Important:
 • Useall4pairs(8pins)oftheLANcable.
 • Themaximumcablelengthis100m{328'}.
 • MakesurethatthePoEdeviceinuseiscompliantwithIEEE802.3afstandard.
 • Whenconnectingboththe12VDCpowersupplyandthePoEdeviceforpowersupply,PoE
will be used for power supply.
 • WhendisconnectingtheLANcableonce,reconnectthecableafteraround 2 seconds. When
the cable is quickly connected, the power may not be supplied from the PoE device.
POWER
10BASE T/100BASE-TX
AUDIO OUT MIC/LINE IN
EXT I/O
MONITOR OUT
ACT LINK
12V = IN
GND 4 3 2 1
INITIAL
SET
SD CARD/ABF
ALARM IN 1/DAY/NIGHT IN
AUX OUT
ALARM OUT
To 12 V DC
power supply*
(This illustration represents
WV-SP306.)
(12 V DC)
(GND)
12 V DC power
cord plug
(accessory)