16
Before installation
• Whenmountingthecameratoaceilingor
wall,aceilingorwallmountbracketmust
beseparatelyprocured.Thesizeofthe
bracketmountingholeis1/4-20UNCcam-
eratripodmountinghole(depth9mm
{11/32inches}).
• Anchorboltsandscrewsusedtomount
thecameraontheceilingorwallarenot
supplied.Prepareboltsandscrewsthat
matchthestructureandmaterialsofthe
installationlocationandsatisfytheperfor-
manceandreliabilityspecificationsshown
below.
<When mounting on a ceiling>
RecommendedscreworanchorboltM6
orM8x4pcs.
Minimumpull-outstrength(per1pc.)
562N{126lbf}(mountbracket:approx.
260g{0.57lbs},camera:400g{0.88lbs},
lens:40g{0.09lbs})
<When mounting on a wall>
RecommendedscreworanchorboltM6
orM8x4pcs.
Minimumpull-outstrength(per1pc.)
724N{163lbf}(mountbracket:approx.
420g{0.93lbs},camera:400g{0.88lbs},
lens:40g{0.09lbs})
*Whenmountingoneitheraceilingorwall,
oneM4screwwithminimumpull-out
strength(per1pc.)of24.5N{5.5lbf}is
requiredfortheattachmentofthesafety
wire.
Screw tightening
• Thescrewsandboltsmustbetightened
withanappropriatetighteningtorque
accordingtothematerialandstrengthof
theinstallationarea.
• Donotuseanimpactdriver.Useofan
impactdrivermaydamagethescrewsor
causetighteningexcessively.
• Whenascrewistightened,makethe
screwatarightangletothesurface.After
tighteningthescrewsorbolts,perform
checkstoensurethatthetighteningis
sufficientenoughsothatthereisno
movementorlooseness.
Protection from lightning
Whenconnectingtoanetworkusingthenetwork
cableofthisproduct,observethefollowing.
• Whenwiringforthenetwork,designand
engineernottobeaffectedbylightning.
Radio disturbance
WhenthisproductisusednearTV/radio
antenna,strongelectricfieldormagneticfield
(nearamotor,atransformerorapowerline),
imagesmaybedistortedandnoisemaybe
produced.
PoE (Power over Ethernet)
UseaPoEhub/devicethatiscompliantwith
IEEE802.3afstandard.
Router
WhenconnectingthisproducttotheInternet,
useabroadbandrouterwiththeportforward-
ingfunction(NAT,IPmasquerade).
RefertotheOperatingInstructionsonthepro-
videdCD-ROMforfurtherinformationabout
theportforwardingfunction.
Time & date setting
Itisnecessarytosetthetime&datebefore
puttingthisproductintooperation.Refertothe
OperatingInstructionsontheprovided
CD-ROMfordescriptionsofhowtoperform
thesettings.
Make sure to remove this product if it will
no longer be used.