42
Table of beep tones
The following table lists the beep tones used by this product.
Category Message Beep tone*
1
Customer
notification
Lane A
BEE (at intervals of
2 seconds or so)
Lane B
BU-BU (at intervals of
2 seconds or so)
System
notification*
2
Mode change
(Start of speed team operation)
BU-BUU
Message
recording*
2
Message recording start BUU
Message recording end BU-BU
Message recording end countdown BUU-BUU-BUU-BEE
Talk & Page
Communication establishment
(Talk start, Page start, alert notification)
BEE
Communication end
(Talk end, Page end)
BU-BU
In-range notification tone
(When the status in which
communication with the Center Module
is enabled has been established from
the out-of-range status)
BE-BEE
Communication error
(When talking, paging, etc. is not
possible)
BU-BU-BU-BU
Volume adjustment
Volume change BEE
Volume change (upper limit) BE-BEE
Other
Error occurrence BUU-UU-UU
Remaining battery level warning
BUU-UU (at intervals of
5 seconds or so)
Setting mode
Started in setting mode BEE-BEE-BEE-BEE-BEE
Setting confirmation BEE
*1 Some tones may sound the same but their intervals or speed may differ.
*2 For details, refer to the operating instructions (Installation Guide and Setup Instructions)
for the Center Module.
WX-CH457P_PUQX1020ZAV1.indb 42 2021/07/02 14:31:25
To Next Page
Loading...
