Panini XL - Functioning and Manipulation; Installation and Assembly; First Starting

Commutator Thermostat control knob
On/off pilot light Drip tray
Thermostatic pilot light
5. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place the contact-grill on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible materials
even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
- Remove the protective film from the upper cover without forgetting the one on the drip
tray (n°5 on picture)
b) First starting:
Before the first use, remove the anti-corrosion protection fat with a cleaner. Then, it is
necessary to grease plates with oil.
During the first use, warm your machine up outside during about 30 min to evacuate
residual smokes of manufacturing oil from the metallic parts. This may emit a slight
smell for a few moments.
4
1
2
4
5
3
1
2
3
4
5
9