Panphonics AA-160 - Page 2

Sound Shower AA-160e / AA-160mm Operation Manual v.2.0 26.3.2012 ©
Panphonics Oy 2/7
ip#update#
Take&new&ip&settings&in&use.&After&”ip&update”&a&new&connection&must&be&made&and&settings&saved&
by&issuing&”save&setup”.&If&the&new&settings&are&not&saved&after&”ip&update”&the&unit&will&
reboot&after&about&5&minutes&and&return&back&to&the&old&settings.&
Usage:&ip&update&
Output:&NA&
&
ip#password#
Change&password&of&the&ip&connection.&New&password&must&be&repeated&twice&after&the&command,&
passwords&are&to&be&separated&by&a&space&character.&The&default&password&is&'passu'.&Maximum&
length&of&the&password&is&16&characters.&
Usage:&ip&password&passu&passu&
Output:&OK&
Changing standby mode ON/OFF
The amplifier standby mode can be chanced remotely using ‘PWRON’ / ‘PWROFF’ –
commands. The current status can be checked by using ‘STATUS’ command.
STATUS#
Amplifier&status&query,&returns&ON/OFF&depending&on&the&amplifier&state&
Usage:&STATUS&
Output:&STATUS24,OFF&
&
PWRON#
Amplifier&power&on&command&
Usage:&PWRON&
Output:&STATUS03,ON&
&
PWROFF#
Amplifier&power&off&command&
Usage:&PWROFF&
Output:&STATUS49,OFF&
Selecting Input
The input interface can be selected using the ‘input’ –command. The default input is
RCA.
input#x#
Select&audio&input:&'input&xlr',&'input&rca'&
Usage:&input&rca&
Output:&OK&
Adjusting Volume
The current volume setting can be checked with ‘VOLREAD’ –command. The volume
can be changed by commanding ‘VOL00‘– ‘VOL37’. The minimum is ‘VOL00’ and the
maximum is ‘VOL37’. Any value between the 00 and 37 can be given. If the setting
should be permanent (even during the power failure), use the ‘VOLSAVE’ –command
to save the setting.
VOLREAD#
Read&current&volume&setting&from&the&unit&
Usage:&VOLREAD&
Output:&VOL=22&
&
VOLxx#
Set&volume&VOL00^VOL37&
Usage:&VOL15&
Output:&STATUS00,ON&
VOLSAVE#
Save&volume&setting&to&Flash&memory&
Usage:&VOLSAVE&
Output:&OK&