Pantum M7310 Series User Manual

87
3) Click on "Device" and select WIA Scan,click the “Custom Insert” below.
4) The prompt window as is shown below, set the scan information.
5) Click on "Adjust the Scanned Image Quality" on the bottom left corner of the above picture, the
advanced properties interface will pop up, then users can set the scan; After finishing the settings,
click on the "OK" button, then "Scan" button to start scan.

Pantum M7310 Series Specifications

General

Brand	Pantum
Model	M7310 Series
Category	All in One Printer
Language	English