8
b) Slide the manual feed guides to match both sides of the paper.
c) Raise the output tray to avoid the paper from slipping and falling.
d) Put the print media like an envelope or transparency into the manual feeder tray with two hands
until the front end of the envelope or transparency contacts the correction roller.
• When loading paper into the manual feeder tray, the printer will automatically enable the
manual feed mode.
• Load the paper into the manual feeder tray with the print-side up. When loading, the top of
the paper first enters into the manual feeder tray.
• Ensure that the paper, envelope or transparency is loaded straightly and in the correct
position of the manual feeder tray. Otherwise, it will result in a skewed printout or a paper
jam.
e) After the printed page is output from the printer, load another paper according to the above steps
to continue printing.
After printing, please immediately remove the paper, envelopes and transparencies. Stacking
paper or envelopes may cause a paper jam or the paper curling.
To Next Page
Loading...
Need help?
General
