Paragon Atlanta - Setting the daily alarms; The alarm for opening and closing; Snooze function; Displaying temperature and temperature trend

Setting the daily alarms:
 Press and hold down “MEM” button more than 2 seconds until Alarm 1 Time hour display of the Alarm 1
time starts to flash. Use the “+” and “-” buttons to set the required hour.
 Press “MEM” button to confirm your setting, The Minute display of the Alarm 1 time starts to flash. Use the
“+” and “-” buttons to set the required minute.
 Press “MEM” button to confirm your setting, The hour display of the Alarm 2 time starts to flash. Use the “+”
and “-” buttons to set the required hour.
 Press “MEM” button to confirm your setting, The Minute display of the Alarm 2 time starts to flash. Use the
“+” and “-” buttons to set the required minute.
 Press “MEM” button to confirm your setting and to end the setting procedure.
F.Y.I.:
 After 20 seconds without pressing any button the clock switches automatically from setting mode to Normal
clock mode.
The alarm for opening and closing
 The alarm 1 or alarm 2 shift switch is pushed in the “ON” position, LCD display the “ ” or “ ”icon, the
alarm 1 or alarm 2 function is open
 Product back of the alarm shift switch is pushed in the “OFF” position, the “ ” or “ ”icon disappears, the
alarm 1 or alarm 2 function is close
F.Y.I.:
 The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the alarm
will be repeated automatically after 24 hours.
 Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst the alarm signal is
heard.
Switching off the alarm signal
 Press any button except the “ ” button to stop the alarm signal. It is not necessary to reactivate the
alarm. It switches itself automatically to the alarm time which has already been set.
Snooze function:
 Touch the " " field or press the “ ” button the alarm signal sounds to get to SNOOZE mode. The
alarm signal sounds again after approx. 5 minutes.
Displaying temperature and temperature trend
 The current indoor temperature and the temperature trend (indoor) are shown in the LCD display.
 After successfully connecting with the outdoor sensor, the weather station can display the outdoor
temperature and the temperature trend (outdoor)
 You may see the following displays:
The temperature is rising.
The temperature is remaining constant.
The temperature is falling.