What to do if TheSkyX cannot connect to Paramount Fitness ME II after adding a USB hub?
If TheSkyX Professional Edition cannot connect to the Paramount after adding a USB hub, USB cable extender, or any other USB peripheral device, remove the USB hub or extender. Plug the 15-foot USB cable supplied with the Paramount directly into the computer’s USB port and the port labeled USB on the Electronics Box.
What to do if Paramount Fitness ME II Telescope beeps continuously and won't slew?
If the Paramount Fitness Telescope emits continuous, successive, high-pitched beeps shortly after startup and will not slew, check that the balance knobs are adjusted properly. If the balance knobs are too tight, the worm is forced against the gear, and the mount will not slew. Check the mount balance in both axes. If the Paramount stalls or sounds labored while slewing, check to make sure both axes are properly balanced.
How to avoid communication errors on Paramount Fitness ME II Telescope due to power management?
To avoid communication errors with your Paramount Fitness Telescope due to power management settings, edit the computer's power management settings and disable the USB Selective Suspend setting.
What to do if Paramount Fitness Telescope will not slew?
If the Paramount Fitness Telescope will not slew, make sure the Three Position Switches in both right ascension and declination are in the Track position.
How to fix TheSkyX Professional Edition when it cannot communicate with Paramount Fitness Telescope?
If TheSkyX Professional Edition cannot communicate with the Paramount Fitness Telescope, ensure that the software and hardware are properly configured. Try the following: 1. Make sure the mount is powered on. 2. Make sure the plugs on each end of USB 2.0 cable are seated properly. 3. Make sure the software settings are correct. 4. See “USB Hubs and USB Extenders” on page 167.
General| Brand | Paramount Fitness |
|---|---|
| Model | ME II |
| Category | Telescope |
| Language | English |
To Next Page