6-4 Programming Your Application
590 Series DC Digital Converter
Function Block Descriptions
Note: Remember to select the correct mode, Parameterisation or Configuration, whilst editing.
Refer back to “
Modifying a Block Diagram”, page 6-1. You must select the full view
level to see all of the function blocks, go to MENUS menu at level 1 on the MMI.
* These function blocks contain parameters from the DIAGNOSTICS menu on the MMI.
Function Block Page
MAIN PORT P1 6-36
MENUS 6-37
miniLINK 6-38
PID 6-39 *
RAISE/LOWER 6-42 *
RAMPS 6-44 *
SETPOINT SUM 1 6-48 *
SETPOINT SUM 2 6-49
SPEED LOOP
ª SETPOINTS
6-51 *
ADVANCED (Speed Loop)
ª ADAPTION
ª ZERO SPD QUENCH
6-55
STANDSTILL 6-56 *
STOP RATES 6-57 *
SYSTEM PORT P3
ª P3 SETUP
ª BISYNCH SUPPORT
ª 5703 SUPPORT
6-59
TAPER CALC 6-60
TENS+COMP CALC 6-61
TORQUE CALC 6-63
USER FILTER 6-64
Function Block Page
ANALOG INPUTS 6-5 *
ANALOG OUTPUTS 6-7 *
AUX I/O 6-8 *
AUX PORT P2 6-10
CALIBRATION 6-11 *
CURRENT LOOP 6-14 *
CURRENT PROFILE 6-17
DIAGNOSTICS 6-18 *
DIAMETER CALC 6-22
DIGITAL INPUTS
ª DIGITAL INPUT C4 & C5
6-24
DIGITAL OUTPUTS 6-26
FIELD CONTROL
ª FLD VOLTAGE VARS
ª FLD WEAK VARS
6-27 *
INHIBIT ALARMS 6-30
JOG/SLACK 6-32 *
LINK 11 & LINK 12 6-34
To Next Page
Loading...
