D-108 Programming
DC590+ DRV Series DC Digital Drive
SELECT
Used to select a value from one of eight inputs,
depending on the value of the select input. A second
output is provided to allow the block to be used as
two banks of four inputs.
SELECT
Parameter Tag Range
INPUT 0 to INPUT 7 1156 to 1163 -32768.00 to 32768.00
Inputs to the select block
SELECT 1164 0 to 7
Determines which of the inputs is routed to OUTPUT 1 . In addition, if SELECT INPUT is in the range 0 to 3, INPUT 4 to INPUT 7 respectively is
routed to OUTPUT 2, otherwise OUTPUT 2 is unchanged.
OUTPUT 0 1165
⎯.xx
Selected output
OUTPUT 1 1166
⎯.xx
Alternative selected output from INPUT 4 to INPUT 7 if SELECT is less than 4.
To Next Page
Loading...
