Parker 700 Series - Service Parts List

Bulletin 1531-001/USA
Pump/Motor Division
700 Series Service Procedure
Parker Hannin Corporation
Hydraulic Pump/Motor Division
Greeneville, TN 37745 USA
8
Item No. Qty Part Number Description
 1 8 See Following Page Bolts
2 1 M110C-6 4 Dowel End Cover (standard)
1 M110C-23 Encoder End Cover, 4 Dowel End Cover BSPP
3 6 1046 O-Rings
4 1 See Following Page IGR™ Set, Rear
5 2 1660 Clip, 2 Pieces
6 1 See Following Page Shaft, Internal
7 2 SM015995 Commutator Plate
8 4 1021 Check Ball
9 1 See Following Page Center Block
10 4 25060-09 Bolt, 5/16-18x1.00, G8
11 1 See Following Page Shaft, Output
12 1 PA-2984-1 1.25" Shaft "A" Flange (with seals)
1 PA-2984-2 1.25" Shaft "B" Flange (with seals)
13 1 1060-34 O-Ring Flange, 2-034
14 2 040230-0565 Dowel
15 8 See Following Page Bolt
16 1 See Following Page Front Bearing Housing
17 1 See Following Page IGR™ Set, Front
18 2 036300 7/8-14 SAE Plug
19 1 1826 Spring, Two Speed Valve Return Spring
20 1 1825 or 2792 Valve - 1825 Open Center
2792 Closed Center
21 4 1320 Check Balls-Solenoid Block
22 5 032841 O-Rings-Solenoid Block
23 1 1823 Solenoid Block (Aluminum)
24 1 481006 Solenoid-With Manual Override
1 2891 Solenoid-Without Manual Override
25 2 021442 Bolt, 5/16-24 x 1.875"
26 1 2271 1.25" Dia. Shaft Thrust Washer
27 1 2270 1.25" Dia. Shaft Thrust Bearing
28 1 2150 1.25" Dia. Shaft Seal, High Pressure
29 1 1435 1.25" Dia. Shaft Seal, Dust, 1.312"
30 1 1323 1" Dia. Shaft Thrust Washer
31 1 1585 1" Dia. Shaft Thrust Bearing (pressed into ange)
32 1 2175 1" Dia. Shaft Seal, High Pressure, 1.063"
33 1 1325 1" Dia. Shaft Seal, Dust, 1.062"