Parker Hannifin
- 42 - Aries Controller Hardware Installation Guide
Assigning IP Addresses
Communication between the Aries Controller and your PC must be set up
before connecting over the Ethernet network. Do this by first setting the IP
address of the Aries Controller, and then setting the IP address and subnet
mask for the PC.
Setting the IP Address—Aries Controller
The factory assigns the following to each Aries Controller:
IP Address
Subnet Mask (fixed)
192.168.100.01 255.255.255.0
Before adding the Aries Controller to the network, complete its IP address by
setting the last two octets (digits) of the IP address on the rotary decimal
switches. The last octet can be any number from 1 through 99 (00 is not
valid).
One rotary switch is marked X1 and the other X10. X1 is the “ones” position
and X10 is the “tens” position. For example, to set the address to 14, turn the
pointer of the X10 switch to 1, and the X1 switch to 4 (10 + 4 = 14). See
Figure 24. This IP address is now set to 192.168.100.14.
Figure 24 IP Address Switches (Set to 14)
To Next Page
Loading...
