Parker Hannifin
- 44 - Aries Controller Hardware Installation Guide
5. Select Internet Protocol (TCP/IP) and click on the Properties button.
You should get a window similar to this:
Figure 27 Internet Protocol (TCP/IP) Properties Screen
6. Click on the radio button next to “Use the following IP address:” and
type in an IP address with the same first three octets as the default
Aries Controller IP address (192.168.100). Set the last octet to a
number different from the number you set with the Address Switches
on the faceplate of the Aries Controller. (See the section Setting the
IP Address—
Aries Controller.) Making the last octet different gives
the Aries Controller and your PC different IP addresses in the
Ethernet network. The valid range is 1 to 254. Using 000 or 255 is
not valid.
In the example in the next step, the IP address is set to
192.168.100.25.
To Next Page
Loading...
