Bulletin TI-H2PEMPD-D Installation, Operation and Maintenance Manual
Hydrogen Gas Generator H2 PEMPD series
14
1-800-343-4048 www.parker.com/balston
4.3 Operating Menus
There are 8 menus used by the generator to display and access operational parameters and data. These can be accessed from the
default menu by sequentially pressing on the control panel. These menus are shown in table 10.
Table 10
4.3.1 Default Menu
The default menu displays the following data:
Figure 10
SET - The outlet pressure required by the application.
The required outlet pressure can be adjusted up and down using the and keys respectively.
ACT - Current actual internal / outlet pressure of the generator.
LOAD X/ -Indicates the status of the generator outlet valve. “X” - Outlet is closed, “ “- Outlet is open.
100% - The shaded blocks indicate the rate of hydrogen production. Each block represents 20% of the
rated capacity of the generator.
During initial startup, all five blocks will be shaded indicating that the generator is building up pressure and not currently
on line. When the generator is on-line and delivering gas to the application, the number of blocks shaded will depend
upon the flow required by the application.
1 Defa ul t
2 Conductivity (wa ter qua l ity)
3 Pres s ure - uni ts of mea s urement
4 Run ti me / Servi ce interva l
5 Flow
6 Error log
7 Generator s el f test
SET 100 PSI LOAD√
ACT 100 PSI
CONDUCTIVITY
X √
PRESSURE UOM
PSI
HOURS RUN XXXXX
SERVICE IN XXXXX
FLOW ml/MIN 000
LITERS 000
ERROR LOG
HOLD &
** SELF TEST **
HOLD &
SET 100 PSI LOAD√
ACT 100 PSI
To Next Page
Loading...
