Parker Helac PowerTilt PT-4.5 - PowerTilt PT-4.5 Quick Coupler Installation

9
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.helac.com
PowerTilt Tilting Coupler
PT-4.5 Service & Repair Manual
HY34-1370
Install Quick Coupler
1. Install coupler on PowerTilt. Insert 8 ea. M10
screws (114) with washers (115) through lock
plate (412) and torque to 68 Nm (50 ft-lbs).
.
2. Insert screw (409), 1” tie-rod bolt through
center of PowerTilt from the torque foot end,
install spacer (410) and lock-nut (411) and
torque to 920 Nm (680 ft-lbs).
.
Install Quick Coupler