Parker Hi-drive - Connector Layout; Parking Brake

Parker Hannifin S.p.A. – S.B.C. Division quick installation guide Hi-drive
Page 6 of 12
3.3 Connector layout
(*) The yellow and green LEDs are active if, when the drive supply is connected (24Vdc), the drive
electronics is operating.
The red LED, called “STATUS” provides a series of information on the state of the converter:
- off the converter is disabled without active alarms.
- on the converter is enabled: the drive is in RUN mode
- flashing with interval between the 2 series of flashes, the converter is disabled and an
alarm has tripped; the tripped alarm can be identified by counting the number of flashes
between two intervals.
- Continuous fast flashing indicates the command I
2
t is active, the converter remains
enabled.
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
X5
X6
X3
brake
X4
X7
X8
X9 X10
X11
X2
motor
X1 – mains
Status Led
(
*
)
Hi driv
e
Lower panel
Module Display/Keypad
(optional)
Top panel
Power terminal (top
panel)
otherwise
“MOTIONWIZ”
on CD-Rom enclosed in stock
MAI
NS
M
O
T
O
R
PARKI
NG
BRAKE