8
CHANGING MODE
Push ESC button to enter sub menus. IF Mode does not appear, press UP/DN button
until MODE screen appears.
Press F1 to select MODE, then press UP/DN to scroll to desired number.
Use Up / Down
for
Desired mode
b
Once MODE number is selected for the correct operator press F1.
NOTE: F1, F2, F3 refer to the commands above them in the LCD screen. The label
display above F1 menu is OK, above F2 is CANCEL, and Above F3 is blank.
If F2 is selected the changes just made will be voided and the original position that was
started will stay.
Once complete, hit ECS button until main display screen appears.
The ESC button will access the sub menus and leave the sub menus once selections are
made.
NOTE: MODE 4 is the manufacturers default setting, if a operator tunes the machine to a
poor performance. The MODE 4 setting can be set and the machine performance
verified with factory settings. If machine performs satisfactorily in MODE 4 then the
operator has tuned their settings to a limiting condition. At this point, either the MODE
PROPERTIES can be reconfigured or MODE 4 needs to be copied over the non adjusted
MODE.
To Next Page
Loading...
